LogoLogo
  • EWS Series User Manual
  • Product Overview
    • Introduction
    • LED Behavior
    • Comparison Table
    • Technical Specification
  • Getting Started
    • Management Interface
    • Connecting the Switch
  • Wireless Controller Features
    • Managing EnSky Access Points
    • Device Management
      • Access Points
      • Access Point Settings
      • AP Groups
      • Wireless Services
    • Monitor
      • Active Clients
      • Rogue AP Detection
      • System Log
      • Email Alert
    • Visualization
      • Topology View
      • Map View
      • Floor View
      • Mesh View
    • Statistics
      • Access Points
      • Wireless Clients
      • Real-Time Throughput
    • Hotspot Services
      • Captive Portal
      • Guest Account
    • Mesh
      • Mesh Profile
      • Node List
      • Mesh Tools
      • Isolated Nodes
    • Maintenance
      • Schedule Tasks
      • Troubleshooting
      • Bulk Upgrade
      • One-click Update
      • SSL Certificate
      • Check Codes
  • Ethernet Switch Features
    • System
      • Summary
      • Network Settings
      • System Time
      • Port Settings
      • PoE
      • EEE
    • L2 Features
      • Link Aggregtion
      • STP
      • MAC Address Table
      • LLDP
      • IGMP Snooping
      • MLD Snooping
      • Jumbo Frame
    • VLAN
      • 802.1Q
      • PVID
      • Voice VLAN
    • Management
      • System Information
      • User Management
      • Dual Image
      • SNMP
    • ACL
      • MAC ACL
      • MAC ACE
      • IPv4 ACL
      • IPv4 ACE
      • IPv6 ACL
      • IPv6 ACE
      • ACL Binding
    • QoS
      • Global Settings
      • CoS Mapping
      • DSCP Mapping
      • Port Settings
      • Bandwidth Control
      • Storm Control
    • Security
      • 802.1x
      • Radius Server
      • Access
      • Port Security
      • Port Isolation
      • DoS
    • Monitoring
      • Port Statistics
      • RMON
      • Log
    • Diagnostics
      • Cable Diagnostics
      • Ping Test
      • IPv6 Ping Test
      • Trace Route
    • Maintenance
      • Configuration Manager
      • Firmware Upgrade
  • Appendix
    • Appendix A
    • Appendix B
    • Appendix C
Powered by GitBook
On this page

Was this helpful?

Export as PDF
  1. Ethernet Switch Features
  2. QoS

Port Settings

PreviousDSCP MappingNextBandwidth Control

Last updated 4 years ago

Was this helpful?

From here, you can configure the QoS port settings for the switch. Select a port you wish to set and choose a CoS value from the drop-down box. Next, select to enable or disable the Trust setting to let any CoS packet be marked at ingress.

Port

Displays the ports for which the CoS parameters are defined.

CoS Value

Select the CoS priority tag values, where 0 is the lowest and 7 is the highest.

Trust

Select Enabled to trust any CoS packet marking at ingress. Select Disabled to not trust any CoS packet marking at ingress.

Click Apply to update the system settings.