LogoLogo
  • EWS Series User Manual
  • Product Overview
    • Introduction
    • LED Behavior
    • Comparison Table
    • Technical Specification
  • Getting Started
    • Management Interface
    • Connecting the Switch
  • Wireless Controller Features
    • Managing EnSky Access Points
    • Device Management
      • Access Points
      • Access Point Settings
      • AP Groups
      • Wireless Services
    • Monitor
      • Active Clients
      • Rogue AP Detection
      • System Log
      • Email Alert
    • Visualization
      • Topology View
      • Map View
      • Floor View
      • Mesh View
    • Statistics
      • Access Points
      • Wireless Clients
      • Real-Time Throughput
    • Hotspot Services
      • Captive Portal
      • Guest Account
    • Mesh
      • Mesh Profile
      • Node List
      • Mesh Tools
      • Isolated Nodes
    • Maintenance
      • Schedule Tasks
      • Troubleshooting
      • Bulk Upgrade
      • One-click Update
      • SSL Certificate
      • Check Codes
  • Ethernet Switch Features
    • System
      • Summary
      • Network Settings
      • System Time
      • Port Settings
      • PoE
      • EEE
    • L2 Features
      • Link Aggregtion
      • STP
      • MAC Address Table
      • LLDP
      • IGMP Snooping
      • MLD Snooping
      • Jumbo Frame
    • VLAN
      • 802.1Q
      • PVID
      • Voice VLAN
    • Management
      • System Information
      • User Management
      • Dual Image
      • SNMP
    • ACL
      • MAC ACL
      • MAC ACE
      • IPv4 ACL
      • IPv4 ACE
      • IPv6 ACL
      • IPv6 ACE
      • ACL Binding
    • QoS
      • Global Settings
      • CoS Mapping
      • DSCP Mapping
      • Port Settings
      • Bandwidth Control
      • Storm Control
    • Security
      • 802.1x
      • Radius Server
      • Access
      • Port Security
      • Port Isolation
      • DoS
    • Monitoring
      • Port Statistics
      • RMON
      • Log
    • Diagnostics
      • Cable Diagnostics
      • Ping Test
      • IPv6 Ping Test
      • Trace Route
    • Maintenance
      • Configuration Manager
      • Firmware Upgrade
  • Appendix
    • Appendix A
    • Appendix B
    • Appendix C
Powered by GitBook
On this page

Was this helpful?

Export as PDF
  1. Appendix

Appendix A

Federal Communications Commission (FCC) EMC Statement

This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference.

(2) This device must accept any interference received, including interference that may cause undesired operations.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

PreviousFirmware UpgradeNextAppendix B

Last updated 4 years ago

Was this helpful?