ESG320

V1.2.80

[New Features]

  • Support CloudBrink service to offer ZTNA (Zero Trust Network Access) solution

  • Adds MAP-E and DS-Lite support to enable IPv6 access in ISP networks using IPv4-based tunneling 

  • Adds IPv6 Ping/ Traceroute support on WAN1 interface for troubleshooting purposes

  • Optimize the performance of the Diag Tool: CPU Usage

  • Allows Ping operations in Diag Tool to follow the active primary WAN interface instead of a fixed WAN1 interface.

  • Enhanced WAN logs to clearly record status: active, inactive, and unstable

[Issues Fixed]

  • Fixed the issue where Client VPN did not follow the default routing rule when Default Route to Remote Hub was enabled in auto S2S VPN configuration

  • Fixed the issue to reduce duplicated log entries when the WAN connection is unstable.

  • Fixed incorrect rule policy order between 1:1 NAT and Port Forwarding

  • Fixed the issue where only one SIP client can connect to SIP server if SIP client ‘s source port was not TCP/UDP 5060

  • Fixed Symmetric NAT type detection failed.

  • Fixed incorrect WAN2 IP address displayed after updating policy route rules

  • Fixed fail to establish 3rd party S2S VPN connection with IKEv1 when Primary WAN public IP changed.

  • Fixed an issue where full tunnel was restricted to Auto VPN mode. It now supports operation without Auto NAT Traversal enabled.

V1.2.71

[Issues Fixed]

  • Fixed issue where Windows/macOS client cannot access ESG320 LSP (Local Status Page) when ESG320 is default configuration.

V1.2.70

[New Features]

  • Support Static Route over VPN: Enables traffic control by manually defining routes over a VPN tunnel, optimizing network efficiency.

  • Support Default Route to Remote Hub: allows routing all traffic through the remote hub for enhanced security and centralized traffic management

  • Support to save device’s log to syslog server for centralized log management

  • Support real-time log download to easy troubleshooting

  • Changes ESG510/ESG610/ESG620 Ethernet LED definition to “Green is high speed; amber is lower speed”

  • Add warning message for WAN/LAN IP conflicts to alert users of potential network issues

  • Enhanced L7 firewall detection to improve accuracy in identifying Layer 7 packets

[Issues Fixed]

  • Fixed issue where only one L2TP connection from a LAN site could be established to an L2TP VPN server at the WAN site

  • Fixed issue where clients failed to obtain an IP address when switching WAN2 and LAN via the Local Status Page (LSP) while the internet was unreachable.

v1.2.68

  • This f/w version is for the first release.

PreviousESG620NextPDU Firmware

Last updated

Was this helpful?