LogoLogo
  • Switch Extender 4GE 1SFP
  • Hardware Installation
  • Management Plane
  • Cloud Management - Cloud To-Go
  • Cloud Management - FitXpress
  • Appendix
    • Technical Support
    • Compliance
    • Declaration of Conformity
    • Disclaimer/ Note
Powered by GitBook
On this page
  • Hardware Installation
  • Place on a Flat Surface
  • Wall Mount
  • Power On Device
Export as PDF

Hardware Installation

Last updated 1 year ago

Hardware Installation

Place on a Flat Surface

The EXT1106 already comes with footpads on the underside. These footpads help secure and protect it from vibration and shock when stacking.

Wall Mount

  1. Determine where the Switch Extender will be placed and mark the location on the surface for the two mounting holes. Use the appropriate drill bit to drill two 8.1mm diagram and 26mm-deep holes on the marks.

  2. Screw the Anchors into the holes until they are flush with the wall; screw the included Screws into the Anchors but leave the screw head sticking out so you can hang the Switch Extender on it.

2. Place Switch Extender against the wall onto the Screw heads.

Power On Device

Connect the Power Adapter to the back of the Switch, and then plug the Power Cord into the power outlet.

We strongly recommend using the Type-C external power source provided with the product. The overvoltage protection for EXT1106 is 6VDC. If you need to use your own external power source, please ensure that its power output does not exceed the rated capacity of the overvoltage protection.

*The display model may be varied according to different models.