Appendix

Technical Support

Compliance

CB (Certification Body) / CE-LVD (Low Voltage Directive)

• IEC 62368-1 ed3

• EN 62368-1 ed3

Electromagnetic Compatibility (EMC)

• EN 55032:2015+A1:2020 (Class A)

• BS EN 55032:2015+A1:2020 (Class A)

• AS/NZS CISPR 32:2015+AMD1:2020

• EN 55035:2017+A11:2020

• BS EN 55035:2017+A11:2020

Electrostatic Discharge (ESD) Immunity

• IEC 61000-4-2:2008

• BS EN 61000-4-2:2009

Harmonic Current Emissions

• EN IEC 61000-3-2:2019+A1:2021

• BS EN IEC 61000-3-2:2019+A1:2021

Radio Frequency Electromagnetic Field Immunity

• IEC 61000-4-3:2020

• BS EN IEC 61000-4-3:2020

Electrical Fast Transient/Burst Immunity

• IEC 61000-4-4:2012

• BS EN 61000-4-4:2012

Voltage Fluctuations and Flicker

• EN 61000-3-3:2013+A2:2021

• BS EN 61000-3-3:2013+A2:2021

Surge Immunity

• IEC 61000-4-5:2014/AMD1:2017

• BS EN 61000-4-5:2014+A1:2017

Conducted Disturbances Immunity

• IEC 61000-4-6:2013

• BS EN 61000-4-6:2014

Power Frequency Magnetic Field Immunity

• IEC 61000-4-8:2009

• BS EN 61000-4-8:2010

Voltage Dips, Short Interruptions, and Voltage Variations Immunity

• IEC 61000-4-11:2020

• BS EN IEC 61000-4-11:2020

Declaration of Conformity

Hereby, EnGenius Networks declare that this product is in compliance with:

• RoHS Directive 2015/863

• WEEE Directive 2012/19/EU

• REACH Regulation

Disclaimer/ Note

• Maximum data rates are based on the IEEE standards. Actual throughput and range may vary depending on many factors including environmental conditions, the distance between devices, radio interference in the operating environment, and the mix of devices in the network.

• Features and specifications are subject to change without notice.

• Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

• Trademarks and registered trademarks are the property of their respective owners. For the United States of America: Copyright © 2023 EnGenius Technologies, Inc. All rights reserved.

Warning

Class I Equipment. This equipment must be earthed. The power plug must be connected to a properly wired earth ground socket outlet. An improperly wired socket outlet could place hazardous voltages on accessible metal parts.

"CAUTION: Risk of Explosion if Battery is replaced by an Incorrect Type. Dispose of Used Batteries According to the Instructions."

CAUTION:

• Lithium Battery Caution: Danger of explosion if battery is incorrectly replaced. Replace only with same or equivalent type. Dispose batteries according to manufac- turer's instructions.

• Disposal of a BATTERY into fire or a hot oven, or mechanically crushing or cutting of a BATTERY, that can result in an EXPLOSION

• Leaving a BATTERY in an extremely high temperature surrounding environment that can result in an EXPLOSION or the leakage of flammable liquid or gas

• A BATTERY subjected to extremely low air pressure that may result in an EXPLOSION or the leakage of flammable liquid or gas.

WARNING: There is danger of explosion if the battery is mishandled or incorrectly replaced. Replace only with the same type of battery. Do not disassemble it or attempt to recharge it outside the system. Do not crush, puncture, dispose of in fire, short the external contacts, or expose to water or the liquids. Dispose of the battery in accordance with local regulations and instructions from your service provider.

Advertissment Équipement de classe I. Ce matériel doit être relié à la terre. La fiche d’alimentation doit être raccordée à une prise de terre correctement câblée. Une prise de courant mal câblée pourrait induire des tensions dangereuses sur des parties métalliques accessibles.

“ATTENTION: Risque d’explosion si la batterie est remplacée par un type incorrect. Mettre au rebus les batteries usagées selon les instructions.“

MISE EN GARDE:

• Pile au lithium Attention: Risque d'explosion si la pile n'est pas remplacée correctement. Remplacez uniquement par un type identique ou équivalent. Jetez les piles conformément aux instructions du fabricant.

• Mise au rebut d'une BATTERIE dans un feu ou un four chaud, ou écrasement ou découpage mécanique d'une BATTERIE, pouvant entraîner une EXPLOSION

• Laisser une BATTERIE dans un environnement extrêmement chaud pouvant entraîner une EXPLOSION ou une fuite de liquide ou de gaz inflammable

• UNE BATTERIE soumise à une pression d'air extrêmement basse pouvant entraîner une EXPLOSION ou une fuite de liquide ou de gaz inflammable.