Hardware Mounting

Hardware Mounting

The access point can be mounted on the Wall and Pole, and please perform the steps for the appropriate installation:

Wall Mount

  1. Determine where the Access Point is to be placed and mark the location on the surface for the four mounting holes. Use the appropriate drill bit to drill four 8.1mm diagram and 26mm-deep holes in the markings.

  2. Screw the Anchors into the holes until they are flush with the wall.

3. Fasten the Mounting Bracket with the included Screws into the Anchors.

4. Hang the Access Point against the wall on the Mounting Bracket.

5. Secure the Access Point on the Mounting Bracket with the secure lock on the side.

Pole Mount

  1. Thread the open end of the Pole Mounting Strap through the two tabs on the Mounting Bracket.

2. Lock and tighten the Pole Mounting Strap to secure the Mounting Bracket onto the pole.

3. Hang the Access Point onto the Mounting Bracket.

4. Secure the Access Point on the Mounting Bracket with the secure lock on the side.

Last updated