LogoLogo
  • FitController User Manual
  • Product Overview
    • Introduction
    • LED Behavior
    • Technical Specification
  • Getting Started
    • Power on Device
    • Logging On
    • Registering Devices to Organization
    • Assigning Devices to Network
    • Device Pairing
  • FitController (VM)
    • Platform Requirements (VM)
    • Software Packages (VM)
  • Working with Organization Trees
    • Hierarchy View
    • Network
  • Managing Devices
    • Managing Access Points
      • Configure and Check AP Details
    • Managing Switches
      • PoE scheduling
      • Getting Switch Analytics
      • Mirror
      • Link Aggregation
    • Managing Clients
    • Topology
  • Configuring Networks
    • Configuring SSIDs
      • 802.11 Settings
      • Configuring Security
      • Client IP Addressing
      • Dynamic VLAN Pooling
      • Advanced Settings
      • QoS
      • Captive Portal
      • Social Login
      • Voucher Service
      • Configuring Splash Page
      • Access control
    • Configuring Radio
    • Configuring VLAN
    • Configuring Switch Settings
    • Firmware Upgrade
    • General Settings
    • Access Control
  • Analytics
    • Device Events
    • System Events
    • Config Logs
  • Managing Organizations
    • Managing Device Inventory
    • Email Alerts
  • Managing Team Members
    • Roles and Permissions
  • Notification & Alerts
    • Notification Center
    • Configuring Alert Settings
  • Appendix
    • Compliance
    • Declaration of Conformity
    • Disclaimer/ Note
Powered by GitBook
On this page
  • FCC
  • CE
  • UKCA
  • ISED
  1. Appendix

Compliance

FCC

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditins: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:

  • Reorient or relocate the receiving antenna.

  • Increase the separation between the equipment and receiver.

  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

  • Consult the dealer or an experienced radio/TV technician for help.

CE

The device complies with Directive 2014/30/EU issued by the Commission of the European Community.

Standards:

  • EN 55032:2015+A11:2020

  • EN 55035:2017+A11:2020

UKCA

Standards:

  • EN 55032:2015+A11:2020

  • EN 55035:2017+A11:2020

ISED

The device is in conformity with the relevant legislation of Innovation, Science, and Economic Development Canada (ISED): 2020

Standards:

  • ICES-003:2020 Issue 7

PreviousAppendixNextDeclaration of Conformity

Last updated 2 years ago