LogoLogo
  • Station6 2x2 Patch
  • Hardware Mounting
  • Powering Station AP
  • Management Plane
  • Option A: App Management
  • Option B: Standalone Configuration
  • Appendix
    • Technical Support
    • Compliance
    • Declaration of Conformity
    • Disclaimer/ Note
Powered by GitBook
On this page
  • Hardware Mounting
  • Wall Mount
  • Pole Mount
Export as PDF

Hardware Mounting

Last updated 2 years ago

Hardware Mounting

The access point can be mounted on the Wall and Pole, and please perform the steps for the appropriate installation:

Wall Mount

  1. Determine where the Access Point is to be placed and mark the location on the surface for the four mounting holes. Use the appropriate drill bit to drill four 8.1mm diagrams and 26mm-deep holes in the markings of the Screw Position Identifier.

  2. Screw the Anchors onto the holes until they are flush with the wall, and then fasten the Mounting Screws into the Anchors.

  1. Hang the Access Point against the wall on the Mounting Screw Heads.

Pole Mount

  1. Thread the open end of the Pole Mounting Strap through the two tabs on the Mounting Bracket of the Access Point.

2. Lock and tighten the Pole Mounting Strap to secure the Mounting Bracket onto the pole.